You can professionally make high temperature and chemical resistant O-Rings to the exact size you need - in either inch or metric.
Here's one of the most practical, time saving, widely used devices for industry ever manufactured.
NOT A STICKY KIT
A vulcanized O-Ring produces a bond with greater elasticity and strength due to molecular bonding. It is the highest quality for dynamic and static services.
INCH AND METRIC CAPABILITY AND MUCH MORE
The vulcanizing die and Viton Cord are now available in a choice of inch and metric sizes. The kit vulcanizes other materials now including Buna N, Fluorel , Silicone, Nordel (EPR), Neoprene, Nitrile, and EPDM. The heater control is available in either 120VAC or 240VAC 100W versions.
NO SPECIAL SKILLS REQUIRED
The Viton O-Ring Heater was designed specifically for ease and speed of operation. Complete easy-to-follow instructions with clear step-by-step drawings are included in each kit. The onboard temperature controller/timer makes it a snap. Put your O-ring in the die, and start the controller - THAT'S IT. The controller will set and maintain the correct temperature, time the bonding cycle, and turn off when done. Making O-Rings couldn't be easier
EACH KIT INCLUDES EVERYTHING YOU NEED
|19" Toolbox to Carry Complete Kit||Complete Workboard with Controller|
|Heating Element and Temp Sensor||Vulcanizing Die (inch, metric, or custom)|
|Viton Vulcanizing||Cutting Knife|
|Cooling Container||Glove and Marking Pencil|
Standard 8 slot die (MF95960.50) available with 0.070", 0.103", 0.139", 0.210", 0.275", 0.312", 0.375", and 0.50". Metric dies from 5.7mm to 12mm.
Special custom dies (MF9596DIY) are available in flat, rectangular, chevron, and irregular cross sections up to 3.5" (87.5mm). See chart below
Typical Custom Dies
Extrusion and Bonded Cross Sections